Snow Melting System Electrical in Burlington: Heated Driveways Planned Around the Panel
By Damion Tyrell, Technology Corporate Electric
Snow melting system electrical in Burlington starts with a hard truth: heating cables under a driveway draw serious, continuous power, so the electrical design — panel capacity, dedicated circuits, controls, and GFCI protection — matters as much as the paving above it. Planned before the driveway is poured or replaced, a system clears snow and ice automatically all winter. Retrofitted without planning, it becomes the load that finally overloads a household service. Technology Corporate Electric designs the electrical side of snow melting for Burlington driveways, walkways, and steps, and we assess capacity the same way we approach a panel upgrade for other major home loads: calculation first, equipment second.
What the system actually draws
Heating cable or mats for a typical two-car Burlington driveway can draw as much as an entire older home once did. That load runs for hours during and after a storm, often at the same time as furnaces, dryers, and dinner cooking. A 200-amp service handles most residential systems comfortably when the layout is zoned sensibly; a loaded 100-amp service usually cannot without load management or a service upgrade. We zone larger driveways so the tire tracks or the steepest section can be heated without energizing the whole slab, which cuts both equipment size and hydro bills. Properties in Roseland and Shoreacres with long, sloped driveways benefit most from zoning. See Technology Corporate Electric for related winter work.
Controls decide whether you love the system
A system on a manual switch gets forgotten or left on. Proper controls use sensors with moisture detection, starting when snow begins and stopping when surfaces are dry. We wire zones to operate automatically, with a manual override for freezing rain. For commercial entrances and industrial loading areas in Burlington, controls tie into building automation where it exists. Residential, commercial, and industrial snow melting all share the same principle: automation is not a luxury feature, it is the difference between a system that protects you and one that bills you.
Timing the work with paving and concrete
The electrical rough-in must happen before the surface goes down — conduit, junction points, sensor placement, and cable layout are coordinated with your paver or concrete contractor, because almost nothing under a finished driveway can be corrected without cutting it open. If a new charger is part of the same project, we coordinate both loads together through our EV charger installation planning so the service is sized once for the whole property. Our electrical service areas across Halton and the GTA include Burlington, Oakville, and Hamilton, where sloped escarpment driveways make these systems especially popular.
Protection, permits, and inspection
Snow melting circuits require ground fault protection for equipment, and the Ontario Electrical Safety Code treats them as a defined installation with specific rules for cable spacing, marking, and control equipment. All of it is ESA-notified work inspected by the Electrical Safety Authority. We test cable resistance before and after the pour — the second test catches construction damage while the paver is still on site to answer for it — and we document zone layouts so a future fault can be located instead of guessed at.
Frequently asked questions
Can snow melting be added under an existing driveway? Not practically. The heating elements sit within or directly under the surface, so installation aligns with a driveway replacement or new build.
What does it cost to run? Operating cost depends on area heated, zoning, and storm hours. Automatic controls and heating tire tracks instead of the full slab keep Burlington systems reasonable.
Should I heat my walkway and steps too? Steps and the walkway to the front door are often the highest-value zones — smaller areas, cleared completely, where falls actually happen.
Plan your Burlington snow melting system early
Bring the electrical design into the driveway conversation before quotes from pavers are signed, not after. To plan snow melting electrical work in Burlington, contact Technology Corporate Electric at 437-435-7053.
Comments